About the Air in FuelThe Damaging Effects of Air in FuelAs we've researched the problems of air/vapor on engines, we have found many books and troubleshooting manuals concerned with the same problem. We've also discovered that some of the world's most well known leading manufacturers have service topics concerned with air/vapor and fuel delivery. You'll see that fuel supply woes and air/vapor are discussed heavily in relation to many problems. We've discovered the following companies diagnosing many problems and relating air/vapor to be a major culprit: - Bosch
- Caterpillar
- Cummins
- Detroit Diesel
- ADS, Association of Diesel Specialist
- Racor/Parker
- Milwaukee School of Engineering
- More to come with research
Huge corporations and schools from around the world recognize air/vapor in fuel as a problem. We've listed only some of the symptoms air/vapor has on engines to help you better understand how serious the affects can be. You will be able to see these topics discussed throughout our documentation. Other factors can create these same symptoms however; we do know that air/vapor will cause these symptoms: - Low Horsepower
- Low Fuel Mileage/Poor Fuel Mileage
- Excessive Smoke
- Injector Failure
- Hard Start or Will Not Start
- Engine Surges at Low Idle
- Warm Engine Runs Rough or Misfires in Operating Range
- Rough Idle
- Engine Will Not Reach Rated Speed When Loaded
In 1990 Caterpillar released a Special Instruction, 651-1250, stating: "Normally No. 2 Diesel Fuel contains about 10% airs in solution, although the air is not visible." Caterpillar also states: "When the amount of dissolved air exceeds 10%, fuel rate and power output are reduced." In slight contradiction to that statement, through our studies and feed back from customers, we've come to one of two conclusions; first, less than 10% dissolved air in fuel still affects the engines performance adversely and/or two, there is always at least 10% dissolved air in fuel. It may be a little of both. January 2006, Caterpillar released another publication, SENR9620-02, discussing the damage caused by air/vapor in fuel to the EUI injectors. Note: These types of injectors are also found in the Ford Powerstroke Engines. The following are quotes from this publication: "If fuel supply pressure is too low, or if fuel flow is restricted due to plugged fuel filters, a vacuum bubble implodes and causes internal damage to the injector. The implosion actually blasts small amounts of material away over time and results in CAVITATION EROTION. This erosion can damage high-pressure sealing surfaces, causing excessive high-pressure fuel leakage during injection and significant loss of performance. The injector must then be replaced to restore performance." They go on to say, "Air bubbles in the supply fuel can contribute to injector tip failures. Tip failures may result in major mechanical damage to the piston and liner, turbocharger and cylinder head." "An air bubble in the tip provides no fluid damping allowing the check to impact the tip with up to 50% greater force." Air/vapor in fuel is very inconsistent. There are many variables to take into consideration, "fuel temperature, pressure on the fuel, specific gravity and the amount of aeration to which the fuel has been subjected," according to the Cummins service topic. While the vehicle is in motion we believe it would be easy to estimate there is more that 10% air/vapor in fuel. The number 1 schools of hydraulics in the country, the Fluid Power Institute at MSOE (Milwaukee School of Engineering) estimates "approximately 75% of hydraulic system failures are a direct result of air". In 1965 Cummins released a Service Topic, File No. 5-135, and discussed air/vapor in fuel in this document. This article came about to address complaints they were receiving about the fuel filters being only partially filled with fuel when removed. They explain how air/vapor form, which was the cause of the filter not being filled with fuel. Note: if the fuel supply is above the filter
|